Cisco Nexus 7000 Series - Page 36

A Commands
action exceptionlog
8
Cisco Nexus 7000 Series NX-OS System Management Command Reference
OL-25806-03
action exceptionlog
To log an exception if the specific conditions are encountered when an Embedded Event Manager (EEM)
applet is triggered, use the action exceptionlog command. To remove the exception log, use the no form
of this command.
action label exceptionlog module module syserr error devid id errtype type errcode code
phylayer layer ports list harderror error [desc string]
no action label exceptionlog module module syserr error devid id errtype type errcode code
phylayer layer ports list harderror error [desc string]
Syntax Description
Defaults None
Command Modes Embedded event manager
Supported User Roles network-admin
vdc-admin
Command History
Usage Guidelines This command does not require a license.
label Unique identifier that can be any string value. Actions are sorted and run in an
ascending alphanumeric sequence using the label as the sort key. If the string
contains embedded blanks, enclose it in double quotation marks.
module module Records an exception for the specified module number.
syserr error Records an exception for the specified system error.
devid id Records an exception for the specified device ID.
errtype type Records an exception for the specified error type.
errcode code Records an exception for the specified error code.
phylayer layer Records an exception for the specified physical layer.
ports list Records an exception for the specified ports.
harderror error Records an exception for the specified hard error.
desc string (Optional) Specifies a description of the exception logging condition.
Release Modification
4.0(1) This command was introduced.