Cisco Nexus 7000 Series - Page 50

B Commands
blink
22
Cisco Nexus 7000 Series NX-OS System Management Command Reference
OL-25806-03
blink
To blink the LED on the system, use the blink command. To restore the default LED state, use the no
form of this command.
Note Beginning with Cisco NX-OS Release 4.1(2), the blink command is not available in Cisco NX-OS
software. Use the locator-led command for this function.
blink {chassis | fan f-number | module slot | powersupply ps-number | xbar x-number}
no blink {chassis | fan f-number | module slot | powersupply ps-number | xbar x-number}
Syntax Description
Defaults None
Command Modes Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines Use the blink command to flash the LED on a component in the system. You can use this blinking LED
to identify the component to an administrator in the data center.
This command does not require a license.
chassis Blinks the chassis LED.
fan f-number Blinks the LED that represents the configured fan number. The range depends on
the platform. Use ? to see the range.
module slot Blinks the module LED. The range depends on the platform. Use ? to see the
range.
powersupply
ps-number
Blinks the power supply LED. The range depends on the platform. Use ? to see
the range.
xbar x-number Blinks the xbar module LED. The range depends on the platform. Use ? to see the
range.
Release Modification
4.0(1) This command was introduced.