Cisco Nexus 7000 Series - Page 509

Show Commands
show flow sw-monitor
481
Cisco Nexus 7000 Series NX-OS System Management Command Reference
OL-25806-03
show flow sw-monitor
To display the status and statistics for a Flexible NetFlow flow monitor, use the show flow monitor
command.
show flow sw-monitor [name exporter-name] [cache [detailed]]
Syntax Description
Defaults Information for all flow exporters configured on the router is displayed.
Command Modes Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines You must have already enabled traffic monitoring with Flexible NetFlow using an exporter before you
can use the show flow exporter command.
This command does not require a license.
Examples This example shows how to display the status and statistics for a flow monitor:
switch# show flow sw-monitor NFC-DC-PHOENIX statistics
Cache type: Normal
Cache size: 4096
Current entries: 4
High Watermark: 6
Flows added: 116
Flows aged: 112
- Active timeout ( 1800 secs) 0
- Inactive timeout ( 15 secs) 112
- Event aged 0
name exporter-name (Optional) Specifies the name of a flow exporter. The name can be any
case-sensitive, alphanumeric string up to 64 characters.
cache Displays the flow of packets generated by the supervisor. Use this command
with the show hardware flow {ip | ipv6} command to get all the flows on
the system.
detailed (Optional) Displays detailed information about the flow of packets.
Release Modification
4.0(1) This command was introduced.