Cisco Nexus 7000 Series - Page 534

Show Commands
show hardware flow l2
506
Cisco Nexus 7000 Series NX-OS System Management Command Reference
OL-25806-03
show hardware flow l2
To display information about NetFlow hardware Layer 2 flows, use the show hardware flow l2
command.
show hardware flow l2 [monitor monitor-name | profile profile-id | vdc vdc-id | vlan vlan-id]
[detail] [instance instance] [module module]
Syntax Description
Defaults None
Command Modes EXEC mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to display detailed output information about the NetFlow Layer 2 flows:
switch(config)# show hardware flow l2 detail
D IF SMAC DMAC ET PktCnt TCP Flags DSCP
monitor monitor-name (Optional) Specifies the name of the flow monitor. The monitor name can be
any case-sensitive, alphanumeric string up to 64 characters.
profile profile-id Optional) Specifies the name of the flow profile. The profile ID range is from
0 to 7.
vdc (Optional) Specifies the virtual device context (VDC) name.
vdc-id (Optional) Virtual device context ID. The range is from 1 to 16
alphanumerical string.
vlan (Optional) Displays a VLAN.
vlan-id (Optional) Displays VLAN ID. The range is from 1 to 4094.
detail (Optional) Displays detailed information about the flows.
instance (Optional) Displays information about the EARL instance.
instance (Optional) Displays the instance number. The range is from 1 to 2.
slot number (Optional) Specifies the slot number. The range is from 1 to 18.
Release Modification
5.1(1) This command was introduced.