Cisco Nexus 7000 Series - Page 610

Show Commands
show port-monitor
582
Cisco Nexus 7000 Series NX-OS System Management Command Reference
OL-25806-03
show port-monitor
To display information about the Simple Network Management Protocol (SNMP) port-monitor
configuration, use the show port-monitor command.
show port-monitor [policy-name]
Syntax Description
Defaults None
Command Modes Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to display the SNMP port-monitor information:
switch(config)# show port-monitor name pm2
switch(config-port-monitor)# show port-monitor pm2
Policy Name : pm2
Admin status : Not Active
Oper status : Not Active
Port type : All Ports
--------------------------------------------------------------------------------
-----------
Counter Threshold Interval Rising Threshold event Falling Threshold event In
Use
------- --------- -------- ---------------- ----- ------------------ -
---- ------
Link Loss Delta 60 5 4 1 4
Yes
Sync Loss Delta 60 5 4 1 4
Yes
Protocol Error Delta 60 1 4 0 4
Yes
Signal Loss Delta 60 5 4 1 4
policy-name (Optional) Policy name. The maximum number of alphanumeric characters is 32.
Release Modification
4.1(2) This command was introduced.