Cisco Nexus 7000 Series - Page 612

Show Commands
show port-monitor active
584
Cisco Nexus 7000 Series NX-OS System Management Command Reference
OL-25806-03
show port-monitor active
To display information about the active Simple Network Management Protocol (SNMP) port-monitor
policies, use the show port-monitor active command.
show port-monitor active
Syntax Description This command has no arguments or keywords.
Defaults None
Command Modes Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to display information about the active SNMP port-monitor policies:
switch(config)# show port-monitor active
Policy Name : test
Admin status : Active
Oper status : Active
Port type : All Ports
--------------------------------------------------------------------------------
-----------
Counter Threshold Interval Rising Threshold event Falling Threshold e
vent In Use
------- --------- -------- ---------------- ----- ------------------ -
---- ------
Link Loss Delta 60 5 4 1 4
Yes
Sync Loss Delta 60 5 4 1 4
Yes
Protocol Error Delta 60 1 4 0 4
Yes
Signal Loss Delta 60 5 4 1 4
Yes
Invalid Words Delta 60 1 4 0 4
Release Modification
4.1(2) This command was introduced.