Cisco Nexus 7000 Series - Page 637

Show Commands
show ptp port
609
Cisco Nexus 7000 Series NX-OS System Management Command Reference
OL-25806-03
show ptp port
To display information about the Precision Time Protocol (PTP) port, use the show ptp port command.
show ptp port {interface [ethernet]}
Syntax DescriptionT
Defaults None
Command Modes Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to display information about the PTP port:
switch# show ptp port
PTP Port Dataset: Eth7/1
Port identity: clock identity: 0:18:ba:ff:ff:d8: e:17
Port identity: port number: 1536
PTP version: 2
Port state: Slave
Delay request interval(log mean): 2
Announce receipt time out: 3
Peer mean path delay: 0
Announce interval(log mean): 1
Sync interval(log mean): 2
Delay Mechanism: End to End
Peer delay request interval(log mean): 0
interface Specifies the interface.
ethernet (Optional) Specifies an Ethernet interface.
Release Modification
5.2(1) This command was introduced.