Cisco Nexus 7000 Series - Page 64

C Commands
cdp advertise
36
Cisco Nexus 7000 Series NX-OS System Management Command Reference
OL-25806-03
cdp advertise
To configure the Cisco Discovery Protocol (CDP) version supported by the device, use the cdp advertise
command. To remove the CDP configuration, use the no form of this command.
cdp advertise {v1 | v2}
no cdp advertise [v1 | v2]
Syntax Description
Defaults None
Command Modes Global configuration mode (config)
if-ethernet-all configuration (config-if-ethernet-all)
if-gig-ether configuration (config-if-gig-ether)
if-eth-base (config-if-eth-base)
if-mgmt-ether (config-if-mgmt-ether)
Supported User Roles network-admin
vdc-admin
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to configure the CDP version:
switch(config)# cdp advertise v2
switch(config)
This example shows how to remove the CDP configuration:
switch(config)# no cdp advertise v2
switch(config)
Related Commands
v1 Specifies CDP Version 1.
v2 Specifies CDP Version 2.
Release Modification
4.0(1) This command was introduced.
Command Description
cdp enable Enables CDP on an interface.