Cisco Nexus 7000 Series - Page 662

Show Commands
show snmp
634
Cisco Nexus 7000 Series NX-OS System Management Command Reference
OL-25806-03
Examples This example shows how to display the SNMP information:
switch(config)# show snmp
sys contact:
sys location: anyplace, Anywhere
0 SNMP packets input
0 Bad SNMP versions
0 Unknown community name
0 Illegal operation for community name supplied
0 Encoding errors
0 Number of requested variables
0 Number of altered variables
0 Get-request PDUs
0 Get-next PDUs
0 Set-request PDUs
0 SNMP packets output
0 Too big errors
0 No such name errors
0 Bad values errors
0 General errors
Community Group / Access
--------- ---------------
Comm2 network-admin
testCommunity vdc-operator
com3 vdc-admin
______________________________________________________________
SNMP USERS
______________________________________________________________
User Auth Priv(enforce) Groups
____ ____ _____________ ______
foo md5 aes-128(no) network-operator
vdc-admin
network-admin
User3 md5 no network-operator
admin md5 des(no) network-admin
user1 md5 des(no) vdc-admin
______________________________________________________________
NOTIFICATION TARGET USERS (configured for sending V3 Inform)
______________________________________________________________
User Auth Priv
____ ____ ____
foo md5 no
(EngineID 11:22:33:44:55)
foo sha no
(EngineID 33:0:33:22:33)
SNMP Tcp Authentication Flag : Enabled.