D-Link DGS-3000 - Page 191

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
187
clear cfm pkt_cnt 16-29
Description
This command is used to clear the CFM packet’s RX/TX counters.
Format
clear cfm pkt_cnt {[ports <portlist> {[rx | tx]} | [rx | tx] | ccm]}
Parameters
ports - (Optional) The ports which require need the counters clearing. If not specified, all ports
3 0 0 0 0 0 0
4 0 0 0 0 0 0
5 0 0 0 0 0 0
6 0 0 0 0 0 0
7 0 0 0 0 0 0
8 0 0 0 0 0 0
9 0 0 0 0 0 0
10 0 0 0 0 0 0
11 0 0 0 0 0 0
12 0 0 0 0 0 0
13 0 0 0 0 0 0
14 0 0 0 0 0 0
15 0 0 0 0 0 0
16 0 0 0 0 0 0
17 0 0 0 0 0 0
18 0 0 0 0 0 0
19 0 0 0 0 0 0
20 0 0 0 0 0 0
21 0 0 0 0 0 0
22 0 0 0 0 0 0
23 0 0 0 0 0 0
24 0 0 0 0 0 0
25 0 0 0 0 0 0
26 0 0 0 0 0 0
DGS-3000-26TC:admin#show cfm pkt_cnt ccm
Command: show cfm pkt_cnt ccm
CCM RX counters:
XCON = Cross-connect CCMs
Error = Error CCMs
Normal = Normal CCMs
MEP Name VID Port Level Direction XCON Error Normal
----------- ---- ----- ------ ---------- ---------- ---------- ----------
DGS-3000-26TC:admin#