D-Link DGS-3000 - Page 20

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
16
config greeting_message 2-12
Description
This command is used to configure the greeting message (or banner).
Format
config greeting_message {default}
Parameters
default - (Optional) Add this parameter to the config greeting_message command will return
the greeting message (banner) to its original factory default entry.
Restrictions
Only Administrators and Operators can issue this command.
Example
To edit the banner:
DGS-3000-26TC:admin#config greeting_message
Command: config greeting_message
Greeting Messages Editor
===============================================================================
DGS-3000-26TC Gigabit Ethernet Switch
Command Line Interface
Firmware: Build 1.10.013
Copyright(C) 2014 D-Link Corporation. All rights reserved.
===============================================================================
<Function Key> <Control Key>
Ctrl+C Quit without save left/right/
Ctrl+W Save and quit up/down Move cursor
Ctrl+D Delete line
Ctrl+X Erase all setting
Ctrl+L Reload original setting
-------------------------------------------------------------------------------
show greeting_message 2-13
Description
This command is used to display a greeting message.