DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
280
config filter icmpv6_ra_all_node trap 22-9
Description
This command is used to enable or disable the filter ICMPv6 RA all-nodes trap state. If the
ICMPv6 RA all-nodes server trap state is disabled, no trap will be sent out.
Format
config filter icmpv6_ra_all_node trap [enable | disable]
Parameters
enable - Specify that the trap for the filter ICMPv6 RA all-nodes will be enabled. The trap for filter
ICMPv6 RA all-nodes will be sent out.
disable - Specify that the trap for the filter ICMPv6 RA all-nodes will be disabled.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To enable the filter ICMPv6 RA all-nodes trap state:
DGS-3000-26TC:admin#config filter icmpv6_ra_all_node trap enable
Command: config filter icmpv6_ra_all_node trap enable
Success.
delete filter dhcpv6_server permit sip 22-10
Description
This command is used to delete a filter DHCPv6 server permit entry.
Format
delete filter dhcpv6_server permit sip <ipv6addr>
Parameters
<ipv6addr> - Enter the source IPv6 address of the entry here.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
To Next Page
Loading...
