D-Link DGS-3000 - Page 283

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
279
Example
To enable the filter ICMPv6 RA all-nodes log state:
DGS-3000-26TC:admin#config filter icmpv6_ra_all_node log enable
Command: config filter icmpv6_ra_all_node log enable
Success.
DGS-3000-26TC:admin#
config filter icmpv6_ra_all_node ports 22-8
Description
This command is used to configure the state of the filter ICMPv6 RA all-nodes packets on the
switch. The filter ICMPv6 RA all-nodes function is used to filter the ICMPv6 RA all-nodes packets
on the specific port(s) and receive the trust packets from the specific source. This feature can be
protected network usable when a malicious host sends ICMPv6 RA all-nodes packets.
NOTE: It only needs to filter the packet of which the destination address is the all-nodes multicast
address (FF02::1).
Format
config filter icmpv6_ra_all_node ports [<portlist> | all] state [enable | disable]
Parameters
<portlist> - Enter a range of ports for configuring the Filter icmpv6_ra_all_node state.
all - Specify all the existing ports on the switch for configuring the Filter icmpv6_ra_all_node
state.
state - Specify whether the port’s filter ICMPv6 RA all-nodes packets function is enabled or
disabled.
enable - Specify that the filter ICMPv6 RA all-nodes packets function is be enabled.
disable - Specify that the filter ICMPv6 RA all-nodes packets function is be disabled.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the filter ICMPv6 RA all-nodes state to enabled for ports 1:
DGS-3000-26TC:admin#config filter icmpv6_ra_all_node ports 1 state enable
Command: config filter icmpv6_ra_all_node ports 1 state enable
Success.
DGS-3000-26TC:admin#