DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
287
DGS-3000-26TC:admin# enable dhcpv6_local_relay
Command: enable dhcpv6_local_relay
Success.
disable dhcpv6_local_relay 23-4
Description
This command is used to disable the DHCPv6 local relay function of the switch
Format
disable dhcpv6_local_relay
Parameters
None.
Restrictions
Only Administrators and Operators can issue this command.
Example
To configure the DHCPv6 local relay global state to disable:
DGS-3000-26TC:admin# disable dhcpv6_local_relay
Command: disable dhcpv6_local_relay
Success.
config dhcpv6_relay 23-5
Description
This command is used to add/delete an IPv6 address which is a destination to forward (relay)
DHCPv6 packets.
Format
config dhcpv6_relay [add | delete] ipif <ipif_name 12> <ipv6addr>
Parameters
add - Add an IPv6 destination to the DHCPv6 relay table.
delete - Delete an IPv6 destination from the DHCPv6 relay table.
ipif - The name of the IP interface in which DHCPv6 relay is to be enabled.
To Next Page
Loading...
