DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
310
Format
config dhcpv6_server ipif [<ipif_name 12> | all] state [enable | disable]
Parameters
<ipif_name 12> - Enter the IP interface name used. This name can be up to 12 characters long.
all - Specify that all the IP interfaces will used.
state - Specify the DHCPv6 server state for the specified interface.
enable - Specify that the DHCPv6 server state for the specified interface will be enabled.
disable - Specify that the DHCPv6 server state for the specified interface will be disabled.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the DHCPv6 Server state of System Interface to enable:
DGS-3000-26TC:admin# config dhcpv6_server ipif System state enable
Command: config dhcpv6_server ipif System state enable
Success.
To Next Page
Loading...
