DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
325
enable dns_resolver 27-8
Description
This command is used to enable the DNS Resolver state of the Switch.
Format
enable dns_resolver
Parameters
None.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the DNS Resolver state to enabled:
DGS-3000-26TC:admin#enable dns_resolver
Command: enable dns_resolver
Success.
disable dns_resolver 27-9
Description
This command is used to disable the DNS Resolver state of the Switch.
Format
disable dns_resolver
Parameters
None.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the DNS Resolver state to disabled:
To Next Page
Loading...
