D-Link DGS-3000 - Page 338

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
334
Example
To enable ERPS:
DGS-3000-26TC:admin#enable erps
Command: enable erps
Success.
DGS-3000-26TC:admin#
disable erps 30-2
Description
This command is used to disable the global ERPS function on a switch.
Format
disable erps
Parameters
None.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To disable ERPS:
DGS-3000-26TC:admin#disable erps
Command: disable erps
Success.
DGS-3000-26TC:admin#
create erps raps_vlan 30-3
Description
This command is used to create an R-APS VLAN on a switch. Only one R-APS VLAN should be
used to transfer R-APS messages.
Note that the R-APS VLAN must already have been created by the create vlan command.