D-Link DGS-3000 - Page 352

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
348
Parameters
None.
Restrictions
None.
Example
To display the filter netbios list created on the Switch:
DGS-3000-26TC:admin#show filter netbios
Command: show filter netbios
Enabled ports: 1-3
DGS-3000-26TC:admin#
config filter extensive_netbios 32-3
Description
This command is used to configure the Switch to filter NETBIOS packets over 802.3 flame on the
specific ports.
Format
config filter extensive_netbios [<portlist> | all] state [enable | disable]
Parameters
<portlist> - Enter the list of ports used for this configuration here.
all - Specify that all the ports will be used this configuration.
state - Specify to enable or disable the filter to block the NETBIOS packet over 802.3 frame.
enable - Specify that the filter state will be enabled.
disable - Specify that the filter state will be disabled.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure filter extensive netbios state.