D-Link DGS-3000 - Page 422

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
418
Parameters
<ipv6addr> - Enter the IPv6 address.
mac_address - Specify the MAC address.
<macaddr> - Enter the MAC address here.
ports - (Optional) Specify a range of ports or all ports.
<portlist> - Enter a range of ports to be configured.
all - Specify to apply to all the ports.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To create a static IPv6 IMPB entry that binds the IPv6 address fe80::240:5ff:fe00:28 to the MAC
address 00-00-00-00-00-11:
DGS-3000-26TC:admin#create address_binding ip_mac ipv6address
fe80::240:5ff:fe00:28 mac_address 00-00-00-00-00-11
Command: create address_binding ip_mac ipv6address FE80::240:5FF:FE00:28
mac_address 00-00-00-00-00-11
Success.
DGS-3000-26TC:admin#
config address_binding ip_mac ipv6address 39-4
Description
This command is used to update an address binding entry using IPv6.
Format
config address_binding ip_mac ipv6address <ipv6addr> mac_address <macaddr> {ports
[<portlist>| all]}
Parameters
<ipv6addr> - Enter the IPv6 address used here.
mac_address - Specify the MAC address.
<macaddr> - Enter the MAC address here.
ports - (Optional) Specify a range of ports to be configured.If the ports are not specified, it will
apply to all ports.
<portlist> - Enter a range of ports to be applied to.
all - Specify all ports to be applied to.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.