DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
431
all - Specify that all the ports will be usd for this configuration.
max_entry - Specify the maximum number of entries.
<value 1-50> - Enter the maximum number of entries used here. This value must be between
1 and 50.
no_limit - Specify that the maximum number of learned entries is unlimited.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To have a maximum of 10 entries can be learned by ND snooping on ports 1 to 3:
DGS-3000-26TC:admin#config address_binding nd_snoop ports 1-3 max_entry 10
Command: config address_binding nd_snoop ports 1-3 max_entry 10
Success.
show address_binding nd_snoop 39-20
Description
This command is used to display the status of ND snooping on the Switch.
Format
show address
_binding nd_snoop {ports <por
tlist>}
Parameters
ports - (Optional) Specify the list of ports used for this display.
<portlist> - Enter the list of ports used for this display here.
Restrictions
None.
Example
To show the ND snooping state:
DGS-3000-26TC:admin#show address_binding nd_snoop
Command: show address_binding nd_snoop
ND Snoop : Enabled
To Next Page