D-Link DGS-3000 - Page 456

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
452
Parameters
destination - Specify the destination which the unauthenticated host will be redirected to.
quarantine_server - Specify the unauthenticated host will be redirected to the
quarantine_server.
jwac_login_page - Specify the unauthenticated host will be redirected to the
jwac_login_page.
delay_time - Specify the time interval after which the unauthenticated host will be redirected.
<sec 0-10> - Enter the time interval after which the unauthenticated host will be redirected.
The delay time must be between 0 and 10 seconds.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure JWAC redirect destination to JWAC login web page and a delay time of 5 seconds:
DGS-3000-26TC:admin#config jwac redirect destination jwac_login_page delay_time
5
Command: config jwac redirect destination jwac_login_page delay_time 5
Success.
DGS-3000-26TC:admin#
enable jwac forcible_logout 42-8
Description
This command is used to enable JWAC forcible logout. When enabled, a Ping packet from an
authenticated host to the JWAC Switch with TTL=1 will be regarded as a logout request, and the
host will be moved back to unauthenticated state.
Format
enable jwac forcible_logout
Parameters
None.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To enable JWAC forcible logout: