D-Link DGS-3000 - Page 466

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
462
create jwac user 42-21
Description
This command is used to create JWAC users in the local database. When “local” is chosen while
configuring the JWAC RADIUS protocol, the local database will be used.
Format
create jwac user <username 15> {vlan <vlanid 1-4094>}
Parameters
<username 15> - Enter the user name to be created.
vlan - (Optional) Specify the target VLAN ID for the authenticated host which uses this user
account to pass authentication.
<vlanid 1-4094> - Enter the target VLAN ID for the authenticated host which uses this user
account to pass authentication. The VLAN ID value must be between 1 and 4094.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To create a JWAC user in the local database:
DGS-3000-26TC:admin#create jwac user 112233
Command: create jwac user 112233
Enter a case-sensitive new password:******
Enter the new password again for confirmation:******
Success.
DGS-3000-26TC:admin#
config jwac user 42-22
Description
This command is used to configure a JWAC user.
Format
config jwac user <username 15> {vlan <vlanid 1-4094>}
Parameters
<username 15> - Enter the user name to be configured.
vlan - (Optional) Specify the target VLAN ID for the authenticated host which uses this user
account to pass authentication.
<vlanid 1-4094> - Enter the target VLAN ID for the authenticated host which uses this user
account to pass authentication. The VLAN ID value must be between 1 and 4094.