D-Link DGS-3000

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
45
Format
config 802.1x authorization attributes radius [enable | disable]
Parameters
radius - If specified to enable, the authorization attributes (for example VLAN, 802.1p default
priority, and ACL) assigned by the RADUIS server will be accepted. The default state is
enabled.
enable - Specify to enable the authorization attributes.
disable - Specify to disable the authorization attributes.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
The following example will disable to accept the authorized data assigned from the RADIUS server:
DGS-3000-26TC:admin#config 802.1x authorization attributes radius disable
Command: config 802.1x authorization attributes radius disable
Success.
DGS-3000-26TC:admin#
show 802.1x 4-10
Description
This command is used to display the 802.1X state or configurations.
Format
show 802.1x {[auth_state | auth_configuration] ports {<portlist>}}
Parameters
auth_state - (Optional) Displays 802.1X authentication state machine of some or all ports.
auth_configuration - (Optional) Used to display 802.1X configurations of some or all ports.
port - (Optional) Specify a range of ports to be displayed. If no port is specified, all ports will be
displayed.
<portlist> - Enter the list of ports used for the configuration here.
If no parameter is specified, the 802.1X system configurations will be displayed.
Restrictions
None.