D-Link DGS-3000 - Page 500

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
496
DGS-3000-26TC:admin#show lldp ports 1
Command: show lldp ports 1
Port ID : 1
-----------------------------------------------------------------
Admin Status : TX_and_RX
Notification Status : Enabled
Advertised TLVs Option :
Port Description Disabled
System Name Enabled
System Description Disabled
System Capabilities Disabled
Enabled Management Address
10.90.90.90
Port VLAN ID Enabled
Enabled Port_and_Protocol_VLAN_ID
1, 2, 3
Enabled VLAN Name
1-3
Enabled Protocol_Identity
(None)
MAC/PHY Configuration/Status Disabled
Power Via MDI Disabled
Link Aggregation Disabled
Maximum Frame Size Disabled
DGS-3000-26TC:admin#
show lldp local_ports 46-10
Description
This command is used to display the per-port information currently available for populating
outbound LLDP advertisements.
Format
show lldp local_ports {<portlist>} {mode [brief | normal | detailed]}
Parameters
<portlist> - (Optional) Enter a range of ports to be configured. When port list is not specified,
information for all ports will be displayed.
mode - (Optional) Specify the display mode.
brief - Display the information in brief mode.
normal - Display the information in normal mode. This is the default display mode.
detailed - Display the information in detailed mode.
Restrictions
None.