D-Link DGS-3000 - Page 502

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
498
DGS-3000-26TC:admin#show lldp local_ports 1 mode normal
Command: show lldp local_ports 1 mode normal
Port ID : 1
-----------------------------------------------------------------------------
Port ID Subtype : MAC Address
Port ID : 00-01-02-03-04-01
Port Description : D-Link DGS-3000-26TC R1.10.013
Port 1
Port PVID : 1
Management Address Count : 1
PPVID Entries Count : 0
VLAN Name Entries Count : 1
Protocol Identity Entries Count : 0
MAC/PHY Configuration/Status : (See Detail)
Link Aggregation : (See Detail)
Maximum Frame Size : 1536
DGS-3000-26TC:admin#
To display outbound LLDP advertisements for port 1 in brief mode:
DGS-3000-26TC:admin#show lldp local_ports 1 mode brief
Command: show lldp local_ports 1 mode brief
Port ID : 1
-----------------------------------------------------------------------------
Port ID Subtype : MAC Address
Port ID : 00-01-02-03-04-01
Port Description : D-Link DGS-3000-26TC R1.10.013
Port 1
DGS-3000-26TC:admin#
show lldp remote_ports 46-11
Description
This command is used to display the information learned from the neighbor parameters.
Format
show lldp remote_ports {<portlist>} {mode [brief | normal | detailed]}
Parameters
<portlist> - (Optional) Enter a range of ports to be configured. When port list is not specified,
information for all ports will be displayed.
mode - (Optional) Specify to display the information in various modes.