D-Link DGS-3000 - Page 523

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
519
DGS-3000-26TC:admin#config mac_notification interval 1 historysize 500
Command: config mac_notification interval 1 historysize 500
Success.
DGS-3000-26TC:admin#
config mac_notification ports 48-4
Description
This command is used to configure the port’s MAC address table notification status settings.
Format
config mac_notification ports [<portlist> | all] [enable | disable]
Parameters
<portlist> - Enter a list of ports used for the configuration here.
all - Specify that all the ports will be used for this configuration.
enable - Enables the port’s MAC address table notification.
disable - Disables the port’s MAC address table notification.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To enable 7th port’s mac address table notification:
DGS-3000-26TC:admin#config mac_notification ports 7 enable
Command: config mac_notification ports 7 enable
Success.
DGS-3000-26TC:admin#
show mac_notification 48-5
Description
This command is used to display the Switch’s Mac address table notification global settings.
Format
show mac_notification