D-Link DGS-3000 - Page 53

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
49
Example
To configure the parameters that control the operation of the authenticator associated with a port:
DGS-3000-26TC:admin#config 802.1x auth_parameter ports 1-20 direction both
Command: config 802.1x auth_parameter ports 1-20 direction both
Success.
DGS-3000-26TC:admin#
config 802.1x init 4-14
Description
This command is used to initialize the authentication state machine of some or all ports.
Format
config 802.1x init [port_based ports [<portlist> | all] | mac_based ports [<portlist> | all]
{mac_address <macaddr>}]
Parameters
port_based ports - Specify the authentication as the port-based mode.
<portlist> - Enter the list of ports used for the configuration here.
all - Specify that all ports will be used.
mac_based ports - Specify the authentication as the MAC-based mode.
<portlist> - Enter the list of ports used for the configuration here.
all - Specify that all ports will be used.
mac_address - (Optional) Specify the MAC address of client.
<macaddr> - Enter the MAC address used here.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To initialize the authentication state machine of some or all:
DGS-3000-26TC:admin#config 802.1x init port_based ports all
Command: config 802.1x init port_based ports all
Success.
DGS-3000-26TC:admin#
config 802.1x auth_mode 4-15
Description
This command is used to configure 802.1X authentication mode.