D-Link DGS-3000 - Page 54

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
50
Format
config 802.1x auth_mode [port_based | mac_based]
Parameters
port_based - Specifies the authentication as the port-based mode.
mac_based - Specifies the authentication as the MAC-based mode.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the authentication mode:
DGS-3000-26TC:admin#config 802.1x auth_mode port_based
Command: config 802.1x auth_mode port_based
Success.
DGS-3000-26TC:admin#
config 802.1x reauth 4-16
Description
This command is used to re-authenticate the device connected to the port. During the re-
authentication period, the port status remains authorized until failed re-authentication.
Format
config 802.1x reauth [port_based ports [<portlist> | all] | mac_based ports [<portlist> | all]
{mac_address <macaddr>}]
Parameters
port_based ports - Specify the authentication as the port-based mode.
<portlist> - Enter the list of ports used for the configuration here.
all - Specify that all ports will be used.
mac_based ports - Specify the authentication as the MAC-based mode.
<portlist> - Enter the list of ports used for the configuration here.
all - Specify that all ports will be used.
mac_address - (Optional) Specify the MAC address of client.
<macaddr> - Enter the MAC address used here.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.