D-Link DGS-3000 - Page 553

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
549
DGS-3000-26TC:admin#config mld_snooping mrouter_ports vlan default add 1-10
Command: config mld_snooping mrouter_ports vlan default add 1-10
Success.
DGS-3000-26TC:admin#
config mld_snooping router_ports_forbidden 52-4
Description
This command is used to designate a range of ports as being not connected to multicast-enabled
routers. This ensures that the forbidden router port will not propagate routing packets out.
Format
config mld_snooping mrouter_ports_forbidden [vlan <vlan_name 32> | vlanid <vlanid_list>]
[add | delete] <portlist>
Parameters
vlan - Specify the name of the VLAN on which the forbidden router port resides.
<vlan_name 32> - Enter the VLAN name here. The VLAN name can be up to 32 characters
long.
vlanid - Specify the ID of the VLAN on which the forbidden router port resides.
<vlanid_list> - Enter the VLAN ID list here.
add - Specify to add the forbidden router ports.
delete - Specify to delete the forbidden router ports.
<portlist> - Enter a range of ports to be configured.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To set up port 11 as the forbidden router port of the default VLAN:
DGS-3000-26TC:admin#config mld_snooping mrouter_ports_forbidden vlan default
add 11
Command: config mld_snooping mrouter_ports_forbidden vlan default add 11
Success.
DGS-3000-26TC:admin#
enable mld_snooping 52-5
Description
This command is used to enable MLD snooping on the Switch. MLD snooping is disabled by
default. When the Switch receives an MLD report packet from a port, this port will be learned as a