D-Link DGS-3000 - Page 568

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
564
Format
clear mld _snooping statistics counter
Parameters
None.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To clear MLD snooping statistics counter:
DGS-3000-26TC:admin#clear mld_snooping statistics counter
Command: clear mld_snooping statistics counter
Success.
DGS-3000-26TC:admin#
config mld_snooping rate_limit 52-20
Description
This command is used to configure the rate limit of MLD control packets that are allowed by each
port or VLAN.
Format
config mld_snooping rate_limit [ports <portlist> | vlanid <vlanid_list>] [<value 1-1000> |
no_limit]
Parameters
ports - Specify a range of ports to be configured.
<portlist> - Enter the range of ports to be configured here.
vlanid - Specify a range of VLANs to be configured.
<vlanid_list> - Enter the VLAN ID list here.
<value 1-1000> - Enter a value between 1-1000 to configures the rate limit of MLD control
packets that the Switch can process on a specific port or VLAN. The rate is specified in packet
per second. The packets that exceed the limited rate will be dropped.
no_limit - Configures the rate limit of MLD control packets that the Switch can process on a
specific port or VLAN. The rate is specified in packet per second. The packets that exceed the
limited rate will be dropped. The default setting is no_limit.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.