D-Link DGS-3000 - Page 569

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
565
Example
To configure the MLD snooping per port rate limit:
DGS-3000-26TC:admin#config mld_snooping rate_limit ports 1 100
Command: config mld_snooping rate_limit ports 1 100
Success.
DGS-3000-26TC:admin#
show mld_snooping rate_limit 52-21
Description
This command is used to display the rate limit of MLD control packets that are allowed by each
port or VLAN.
Format
show mld_snooping rate_limit [ports <portlist> | vlanid <vlanid_list>]
Parameters
ports - Specify a list of ports.
<portlist> - Enter the range of ports to be configured here.
vlanid - Specify a list of VLANs.
<vlanid_list> - Enter the VLAN ID list here.
Restrictions
None.
Example
To display the MLD snooping rate limit from port 1 to 5:
DGS-3000-26TC:admin#show mld_snooping rate_limit ports 1-5
Command: show mld_snooping rate_limit ports 1-5
Port Rate Limit
-------- ---------------
1 100
2 No Limit
3 No Limit
4 No Limit
5 No Limit
Total Entries: 5
DGS-3000-26TC:admin#