D-Link DGS-3000 - Page 588

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
584
Example
To display the filtering status for port 1 and 2:
DGS-3000-26TC:admin#show cpu_filter l3_control_pkt ports 1-2
Command: show cpu_filter l3_control_pkt ports 1-2
Port IGMP Query DVMRP PIM OSPF RIP VRRP
---- ---------- -------- -------- -------- -------- --------
1 Disabled Enabled Disabled Disabled Disabled Disabl
ed
2 Disabled Enabled Disabled Disabled Disabled Disabl
ed
DGS-3000-26TC:admin#
config control_pkt 54-12
Description
This command is used to change the priority and/or Differentiated Services Code Point (DSCP)
fields for specific control packets which are forwarded by software.
Format
config control_pkt [ipv4 [{igmp | vrrp | rip | pim | dvmrp | ospf}(1) | all] | ipv6 [{mld | pim |
ospf | ripng | nd}(1) | all]] replace {priority [<value 0-7> | none] | dscp [<value 0-63> |
none]}(1)
Parameters
ipv4 - Specify IPv4 protocols.
igmp - Specify that the Switch will examine the Internet Group Management Protocol (IGMP)
field within each packet.
vrrp - Specify that the Switch will examine the Virtual Router Redundancy Protocol (VRRP)
field within each packet.
rip - Specify that the Switch will examine the Routing Information Protocol (RIP) field within
each packet.
pim - Specify that the Switch will examine the Protocol-Independent Multicast (PIM) field
within each packet.
dvmrp - Specify that the Switch will examine the Distance Vector Multicast Routing Protocol
(DVMRP) field within each packet.
ospf - Specify that the Switch will examine the Open Shortest Path First (OSPF) field within
each packet.
all - Specify that the Switch will examine all above field within each packet.
ipv6 - Specify the IPv6 protocols.
mld - Specify that the Switch will examine the Multicast Listener Discovery (MLD) field within
each packet.
pim - Specify that the Switch will examine the Protocol-Independent Multicast (PIM) field
within each packet.
ospf - Specify that the Switch will examine the Open Shortest Path First (OSPF) field within
each packet.
ripng - Specify that the Switch will examine the IP Version 6 (IPv6) Routing Information
Protocol - next generation (RIPng) field within each packet.
nd - Specify that the Switch will examine the IP Version 6 (IPv6) Neighbor Discovery (ND)
field within each packet.