DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
585
all - Specify that the Switch will examine all above field within each packet.
replace - Specify to change the priority or DSCP.
priority - Specify the priority value
<value 0-7> - Enter the value between 0 and 7.
none - Specify not to change the priority.
<value 0-63> - Enter the value between 0 and 63
none - Specify not to change the DSCP.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To change the priority of DVMRP packets to 3:
DGS-3000-26TC:admin#config control_pkt ipv4 dvmrp replace priority 3
Command: config control_pkt ipv4 dvmrp replace priority 3
Success.
show control_pkt 54-13
Description
This command is used to display the priority and DSCP values configured for specific control
packets.
Format
show control_pkt {[ipv4| ipv6]}
Parameters
ipv4 - Displays the IPv4 protocols.
ipv6 - Displays the IPv6 protocols.
If no parameter is specified the system will display all protocols.
Restrictions
None.
Example
To display the priority and DSCP values configured for all protocols:
To Next Page
Loading...
