D-Link DGS-3000 - Page 618

DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
614
Example
To change the name and revision level of the MST configuration identification:
DGS-3000-26TC:admin#config stp mst_config_id name R&D_BlockG revision_level 1
Commands: config stp mst_config_id name R&D_BlockG revision_level 1
Success.
DGS-3000-26TC:admin#
show stp mst_config_id 56-9
Description
This command is used to show the MST configuration identification.
Format
show stp mst_config_id
Parameters
None.
Restrictions
None.
Example
show STP MST configuration ID:
DGS-3000-26TC:admin#show stp mst_config_id
Command: show stp mst_config_id
Current MST Configuration Identification
----------------------------------------
Configuration Name : 00-22-22-22-22-00 Revision Level :0
MSTI ID Vid list
------- -----------
CIST 1-4094
DGS-3000-26TC:admin#
config stp mst_ports 56-10
Description
This command is used to configure the ports management parameters.