DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
771
enable snmp linkchange_traps 78-32
Description
This command is used to configure the sending of linkchange traps.
Format
enable snmp linkchange_traps
Parameters
None.
Restrictions
Only Administrators and Operators can issue this command.
Example
To enable the sending of linkchange traps:
DGS-3000-26TC:admin#enable snmp linkchange_traps
Command: enable snmp linkchange_traps
Success.
disable snmp linkchange_traps 78-33
Description
This command is used to configure the sending of linkchange traps.
Format
disable snmp linkchange_traps
Parameters
None.
Restrictions
Only Administrators and Operators can issue this command.
Example
To disable the sending of linkchange traps:
To Next Page
Loading...
