DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
786
Format
config sim_group [add <candidate_id 1-100> {<password>} | delete <member_id 1-32>]
Parameters
add - Specify to add a specific candidate to the group.
<candidate_id 1-100> - Enter the candidate ID to be added to the group here. This value
must be between 1 and 100.
<password> - (Optional) Enter the password of candidate if necessary.
delete - Specify to delete a member from the group.
<member_id 1-32> - Enter the member ID of the member to be removed from the group here.
This value must be between 1 and 32.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To add a member:
DGS-3000-26TC:admin#config sim_group add 2
Command: config sim_group add 2
Please wait for ACK !!!
SIM Configure Success !!!
Success.
To delete a member:
DGS-3000-26TC:admin#config sim_group delete 1
Command: config sim_group delete 1
Please wait for ACK !!!
SIM Configure Success !!!
Success.
config sim 80-6
Description
This command is used to configure the role state and the parameters of the discovery protocol on
the Switch.
To Next Page
Loading...
