DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
76
Example
To configure a TACACS+ authentication server host’s key value:
DGS-3000-26TC:admin#config authen server_host 10.1.1.222 protocol tacacs+ key
"This is a secret."
Command: config authen server_host 10.1.1.222 protocol tacacs+ key "This is a
secret."
Success.
delete authen server_host 5-24
Description
This command is used to delete an authentication server host.
Format
delete authen server_host [<ipaddr> | ipv6 <ipv6addr>] protocol [tacacs | xtacacs | tacacs+ |
radius]
Parameters
<ipaddr> - Enter the server host's IP address.
ipv6 - Specify the server host IPv6 address.
<ipv6addr> - Enter the server host IPv6 address.
protocol - Specify that server host's authentication protocol.
tacacs - Server host’s authentication protocol.
xtacacs - Server host’s authentication protocol.
tacacs+ - Server host’s authentication protocol.
radius - Server host’s authentication protocol.
Restrictions
Only Administrators can issue this command.
Example
To delete an authentication server host:
DGS-3000-26TC:admin#delete authen server_host 10.1.1.222 protocol tacacs+
Command: delete authen server_host 10.1.1.222 protocol tacacs+
Success.
To Next Page
Loading...
