DGS-3000 Series Layer 2 Managed Gigabit Ethernet Switch CLI Reference Guide
877
DGS-3000-26TC:admin# show wac auth_state ports
Command: show wac auth_state ports
P:Port-based Pri:Priority
Port MAC Address Original State VID Pri Aging Time/ Idle
RX VID Block Time Time
------ -------------------- ---- -------------- ---- -- ----------- ----
31 00-05-5D-F9-16-76 1 Authenticating - - 27 -
Total Authenticating Hosts : 1
Total Authenticated Hosts : 0
Total Blocked Hosts : 0
clear wac auth_state 95-17
Description
This command is used to clear the authentication state of a port. The port will return to un-
authenticated state. All the timers associated with the port will be reset.
Format
clear wac auth_
state [ports [<portli
st
> | all] {authenticate
d | authenticating | blocke
d
} |
macaddr <macaddr>]
Parameters
ports - Specify the list of ports whose WAC state will be cleared.
<portlist> - Enter a range of ports.
all - Specify to clear all ports.
authenticated - (Optional) Specify to clear all authenticated users for a port.
authenticating - (Optional) Specify to clear all authenticating users for a port.
blocked - (Optional) Specify to clear all blocked users for a port.
macaddr - Specify to clear a specific user.
<macaddr> - Enter the MAC address here.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To clear the WAC authentication state of ports 1 to 5:
To Next Page
Loading...
