Introduction
SkyView System Installation Guide - Revision AA 1-7
b. The layout of which sensor “widgets” are shown on the screen, sizes, styles, etc. is
completely configurable: SETUP > EMS SETUP > SCREEN LAYOUT EDITOR
14. Common issues for setting up SV-XPNDR-261/262:
a. Ensure that there is a valid tail number set (see above)
b. Ensure that a valid HEX CODE is set: SETUP > TRANSPONDER SETUP > TRANSPONDER
HEX CODE. A caution message – XPNDR HEX CODE NOT SET will appear if a
transponder is configured in SkyView, but the HEX CODE is not set to a valid number.
c. Traffic will not be displayed unless you are in an area covered by an TIS radar site
(US only)
15. Common issues for setting up Dynon Avionics Autopilot
a. Servos must be powered ON
b. Servos must be recognized on SkyView Network (above)
c. AIRSPEED LIMITATIONS must be set (at least one must be actively adjusted from the
defaults) before the Autopilot can be configured: SETUP > PFD SETUP > AIRSPEED.
d. AP SERVO CALIBRATION must be performed: SETUP > HARDWARE CALIBRATION >
AP SERVO CALIBRATION > CALIBRATION.
e. After AP SERVO CALIBRATION is successfully completed, AP status will now be
displayed on the SkyView display top bar.
To Next Page
Loading...
