Dynon Avionics SkyView Classic - Page 534

Appendix I: SkyView System Installation Guide Revision History
29-4 SkyView System Installation Guide - Revision AA
Revision
Revision Date
Description
 Software changes in SkyView Software v2.6 (continued – see Rev E)
 Clarified that cable-side transponder TNC connector is not provided by Dynon Avionics.
 Added SV-BAT-320 connection information for customers making their own harnesses.
 Added OAT connection information for customers making their own harnesses.
 Removed 30K resistor requirement for Rotax trigger coil RPM pickup.
 Clarified SV-GPS-250 connections when multiple displays and/or SV-GPS-250 modules
are involved.
 Added pinout table for Dynon Avionics Capacitance to Voltage Converter for Van’s
Capacitive Plates.
 224 pages
G
March, 2011
 Document number changed to 101320-006
 Software changes in SkyView Software v3.0:
o Added: Serial TIS out to support traffic display on 3rd party devices.
o Improved: Direct-to now uses industry-standard icon instead of "DTO".
o Improved: SL70 serial out now baud rate selectable.
o Improved: Much more information displayed when available for airports
and other aviation features.
o Added: Support for explicit Synthetic Vision licenses.
o Improved: HSI size increased for improved legibility.
o Added: G meter option to PFD page.
o Added: Jeppesen aviation/obstacle data support.
o Added: Support for Kavlico 3PSI fuel pressure sensor (via sensor file
update).
o Added: OEM dimmer support.
o Added: Support for database sharing via Ethernet in multi-display systems.
o Improved/Fixed: SkyView bootup sequence changed to address reports of
displays that do not boot properly, particularly when a SV-BAT-320 is
connected.
o Improved: SkyView displays will now stay on indefinitely if external power is
lost in flight if a battery is connected.
o Added/Improved: Navigation Mapping Software greatly improved. First
version that requires a license to use (through additional purchase) Trial
version with 30 flight hour free trial SkyView systems.
o Added: Support for UMA differential fuel pressure sensor to support Rotax
914 engines (via sensor file update).
o Improved: Cross-wind component always updates, even if base wind
direction and magnitude is not being updated due to aircraft dynamics.
o Fixed: Amps readings of -0 no longer displays negative.
 Added connector labels to SkyView Network Module and Display Diagrams.
 Fixed orientation of SkyView connectors on diagrams.
 Clarified acceptable SV-ADAHRS-200/201 orientation.
 Added additional Garmin 430 and SL30 configuration information.
 Fixed link to AOA information on Dynon Avionics web site.
 Added LED status troubleshooting information for SkyView modules.
 Added product registration information.
 Updated Garmin 480 connection details.
 Added warnings about modifying products and introduction of foreign debris.
 Described improved loss of external power with SV-BAT-320 connected behavior.
 Added G-meter setup information.
 Added recommended Ethernet connection information for multiple display SkyView
systems.
 Clarified GRT Hall Effect Amps sensor support.
 Added information about reconnecting repaired SkyView Network components to a
system after repair.
 Added Synthetic Vision License and Purchase Information.
 Added SV-MAP-270 License and Purchase Information.
 Updated information about obtaining and managing aviation / obstacle databases,
including Jeppesen data support.
 232 pages
H
May, 2011
 Document number changed to 101320-007
 Software changes in SkyView Software v3.1:
o Added: Flight Planning with multiple leg support.
o Added: Option to disable extreme pitch warning indication chevrons.