Dynon Avionics SkyView Classic - Page 91

SkyView Display Installation and Configuration
SkyView System Installation Guide - Revision AA 4-31
On SkyView:
 SETUP MENU > SYSTEM SETUP > SERIAL PORT SETUP > SERIAL PORT x SETUP > SERIAL IN
DEVICE > GARMIN GNC 255 A/B. This will automatically set the SERIAL IN/OUT BAUD
RATE, and SERIAL OUT DEVICE.
 SETUP MENU > SYSTEM SETUP > SERIAL PORT SETUP > SERIAL PORT x SETUP > SERIAL IN
FUNCTION > NAV 1.
Trig Avionics TY91 and TY92 COM Radio
10
SkyView can display COM radio information from the ATR833, GTR 200, GTR 225, GNC 255,
TY91, and TY92 on the SkyView top bar and send COM frequencies to them (TUNE COM).
Note that SkyView does not send database information for the GTR 200 to enable the GTR
200’s “Nearest or Flight Plan Airports” feature.
 Connect the radio’s serial RX to a SkyView serial TX. If you have more than one SkyView
display, make the same connection to all SkyView displays.
 Connect the radio’s serial TX to one of the SkyView serial RX pins on each display. If you
have more than one SkyView display, make the same connection to all SkyView displays.
 Ensure there is a shared ground between the SkyView display, and the radio. If you have
more than one SkyView display, make the same connection to all SkyView displays.
 Configure the serial port on the radio appropriately.
 Configure the serial port: SETUP MENU > SYSTEM SETUP > SERIAL PORT SETUP > SERIAL
PORT x SETUP > SERIAL IN DEVICE >
FUNKE ATR833 or
GARMIN GTR 200 or
GARMIN GNC 255 A/B or
GARMIN GTR 225 A/B or
TRIG TY9X 25KHz ONLY
TRIG TY9X 8.33/25KHz
This will automatically set the SERIAL IN FUNCTION, SERIAL IN/OUT BAUD RATE, and SERIAL
OUT DEVICE.
Set the radio status to be displayed on the top bar: SETUP > SYSTEM SETUP > DISPLAYED COM >
(device you chose above) (PORT x)
and
SETUP MENU > SYSTEM SETUP > DISPLAY COM IN TOP BAR: YES
Emergency Location Transmitter (ELT)
SkyView can provide a GPS data stream to ELTs that accept GPS data in NMEA format.
 Wire a serial transmit (TX) line from one display to the receive (RX) line on the ELT. If you
have more than one SkyView display, make the same connection to all SkyView displays.
 Ensure there is a shared ground between the SkyView display and the ELT. If you have more
than one SkyView display, make the same connection to all SkyView displays.
10
Full TY91/92 8.33 kHz support depends on a future software update from Trig.