SV-ARINC-429 Module Installation and Configuration
13-8 SkyView HDX System Installation Manual - Revision E
Garmin Settings:
"ARINC 429 Configuration" Page:
In 1: High | EFIS Format 2
In 2: Unused by SkyView, configure as needed for other equipment
Out: High | GAMA Format 2
SDI: Common
"VOR/LOC/GS Configuration Page:
Nav Radio: Enabled
ARINC 429 Configuration:
TX Speed: High
SDI: Common
Other Settings: Unused by SkyView
“RS-232 Configuration” Page:
RS232 1 Output: Aviation Output 1
Optional (ADS-B)
If a Dynon Avionics SV-XPNDR-261 is being used for ADS-B Out capability: Another GTN
serial output should be set to “ADS-B+ OUT” format. That serial port should be connected
to the SV-XPNDR-261’s pin 3 through a 1.21k resistor as described in SV-XPNDR-261
Transponder Installation and Configuration. Finally, set SETUP > TRANSPONDER
SETUP > GPS DATA to DIRECT (GARMIN ADS-B/ADS-B+).
SkyView Settings:
SETUP MENU > SYSTEM SETUP > ARINC-429:
(Configure MODULE 1 and MODULE 2 independently)
> INPUT SPEED: HIGH
> INPUT 1: GPS X
> NAVIGATION SOURCE DISP NAME: (user selectable, 7 characters. The name
entered here is displayed as the HSI source and the Flight Plan Source (if this
device outputs a flight plan).
> INPUT 2: NAV X
> NAVIGATION SOURCE DISP NAME: (user selectable, 7 characters. The name
entered here is displayed as the HSI source and the Flight Plan Source (if this
device outputs a flight plan).
> OUTPUT SPEED: HIGH
> ALLOW AUTO SWITCH: YES (LABEL 100P)
Setting ALLOW AUTO SWITCH: to YES (LABEL 100P) (which is the default, including
after upgrading Software to v10.0 or later) allows the GTN to tell SkyView to switch from
GPS to ILS or back when on an ILS overlay approach - SkyView will display whatever
mode the GTN tells SkyView to be in. When in this mode and not on an approach,
switching between the NAV function and GPS function must be performed from the GTN.
If you want to manually select GPS and NAV from the GTN, as you have done prior to
v10.0, SETUP MENU > SYSTEM SETUP > ARINC-429 > ALLOW AUTO SWITCH: NO.
To Next Page
Loading...
