174
20-2-3. Playback and Recording
Four pages of the [VTR/VDCP] menu contain the following control commands.
EXT I/F :SELECT : (STOP/00:00:00:00): 1/4
VTR/VDCP: =VTR1 : DRCT REC=OFF :
EXT I/F : (STOP/00:00:00:00): 2/4
VTR/VDCP: >STOP : >REC : >PLAY : >FF :
EXT I/F : (STOP/00:00:00:00): 3/4
VTR/VDCP: >CUEUP: TC=00:00:00:00
EXT I/F : SHTL : VAR :(STOP:00:00:00:00): 4/4
VTR/VDCP: >0 :>0.0 : >STEP-R :>STEP-F :
Selects a VTR or VDCP channel for control.
Sets DIRECT REC mode to ON or OFF.
Stops the device operation.
Starts recording by pressing F3 while holding down
F2 when DIRCT REC is Off.
Starts recording by pressing F2 when DIRECT REC
is ON.
Starts playback.
Pauses playback while playing back video.
Rewinds or fast-forwards tapes or other video
storage media.
Switches between REW and FF.
Cues up to a location specified by time code value.
Set the time code value in the following way.
1) Press F3 to enable TC Input mode.
2) Enter a value by turning F3 or using the keypad.
The time code for CUE UP should be set in
hh/mm/ss/ff format.
3) Press F3 to set the time code.
Increases or decreases the time code value on a
per-frame basis by turning F3 without pressing F3
beforehand, if time code is already set.
Plays the device to shuttle mode.
Selects the shuttle mode speed.
Plays the device to variable mode.
Selects the variable mode speed.
Reverses the current time code by one frame.
Advances the current time code by one frame.
* VTR control does not support CTL timecode. TC display, CUE UP, STEP-R, and STEP-F do
not work properly if the connected device uses CTL timecode.
To Next Page
Loading...
Need help?
General
