143
16-2. Executing Macros
Let's execute Macro 12 (PAGE1, Number Button 2)
saved in the previous page on the control panel.
(1) Press MACRO in the SELECT/KEYPAD block.
The [MACRO MEMORY] menu is displayed and
the keypad switches to Macro mode.
(2) Turn F1 to select 1 (PAGE 1) in the [MACRO
MEMORY] menu.
Turn F2 to set DIRECT to ON to change the
mode to DIRECT RECALL.
MACRO : PAGE :DIRECT :PAGECLR: : 1/3
MEMORY : =1 : =ON : >OFF : :
(3) Press 2 on the keypad. Macro 12 will be executed on the control panel.
If DIRECT RECALL is Disabled:
If DIRECT is set to OFF in the [MACRO MEMORY] menu, you need to press RECALL after
pressing 2 on the keypad to execute the macro.
16-2-1. Operation Example 1
Recording Actions as Macro 09
Let's perform the following actions and record them
as Macro 09 (PAGE 0, Number Button 9).
-Select PGM for AUX1.
-Select PREV for AUX2.
-Press the KEY1 transition button.
(1) Press MACRO in the SELECT/KEYPAD block.
(2) Press STORE on the keypad to start recording.
(3) Press AUX1 above the KEY/AUX bus
(4) PressPGM.
(5)Press AUX1 above the KEY/AUX bus.
(6) Press PREV .
(7) Press KEY1 to the right side of the fader.
(8) Press STORE to stop recording.
(9) Press 9. The actions are saved as Macro 09.
Executing Macro 09
(1) Press MACRO in the SELECT/KEYPAD block.
(2) Press 9 on the keypad. (The macro is executed if DIRECT is set to ON.)
(3) Press RECALL to execute Macro 09.
Note that if the KEY1 image is already displayed on the program screen, it will be cleared
from the screen.
MENU AT TACH
DIRECT
PAT T
DETACH
SET UP
KEY1
8 9
4 5 6
STILL MATT F ILE
KEY2 DSK1 DSK2
EVENT
MACRO
1 2 3
0
CLEAR
RECALL STORE
ENTER
CK EF F ECT
TRANS RAT E WIPE
SELECT /KEYPAD
±
7
MENU AT TACH
DIRECT
PAT T
DETACH
SET UP
KEY1
8 9
4 5 6
STILL MATT F ILE
KEY2 DSK1 DSK2
EVENT
MACRO
1 2 3
0
CLEAR
RECALL STORE
ENTER
CK EF F ECT
TRANS RAT E WIPE
SELECT /KEYPAD
±
7
To Next Page
Loading...
Need help?
General
