FOR-A HVS-XT100 User Manual

222
21-18-3. Setting Parameters to Default
If menu parameters are able to be reset on the GUI,
Default will be displayed at the bottom of the context
menu.
To reset a parameter:
(1) Click Default in the pop-up menu to change the
mode to Default. "DEF" will displayed as shown
below.
(2) Click on a parameter value (in a select box, text
box or ON/OFF button) to reset the parameter.
To exit Default mode:
Click Default in the pop-up menu again.
21-19. Backing Up Settings
 See section 4-4. "How to Back up Settings"
Either of following two operations backs up panel settings and loads them automatically at
startup. It is recommended to do either operation after changing menu settings.
-Rebooting (Rebooting the switcher instead of turning the power off then on.)
 See section 21-15-1. "SETUP - SYSTEM."
-Saving an event.
 See section 21-13 "EVENT."
When moving to another page after having changed any of the following menu settings, all menu
data are automatically stored as a backup.
-All SETUP menu settings
-All EXT I/F menu settings
-Overwrite-protection for each event, and direct pattern.
-Each macro overwrite-protection and file name.

FOR-A HVS-XT100 Specifications

General

Brand	FOR-A
Model	HVS-XT100
Category	Switch
Language	English