4. Troubleshooting
45900
2/16
45900
Error message: F replenishment
Check Point
Diagnosis
NOTE
• To access the wiring diagrams, click Wiring diagrams in Bookmarks.
00014 When the replenisher cartridge setting part is moved to the upper position after the replenishment cartridge is opened or
cap is cleaned, the Replenisher Cartridge Position Sensor (Upper) does not turn to DARK even after a specified time
has passed.
00015 Opening or cleaning the replenisher cartridge is completed and Replenisher Cartridge Position Sensor (Upper) detects
it.
Although the replenisher cartridge setting part has been moved downwards then, Replenisher Cartridge Position Sensor
(Upper) does not turn to LIGHT even after a specified time has passed.
(When restarting after operation stop such as instant-off)
For details of operation specification, see ☞ 57010.
• For the QSS-3701/3702/3703/LP7500/LP7600, about 507 prints whose size is 127 mm × 89 mm can be processed after the error
whose suffix number is from 00001 to 00006 occurs.
• For the QSS-3704/3705/LP7700/LP7900, about 545 prints whose size is 127 mm × 89 mm can be processed after the error whose
suffix number is from 00001 to 00006 occurs.
• Regarding the suffix numbers 00007 to 00015, print proceeds if an error message is cleared by pressing YES.
Countermeasure
1. Check whether the replenisher cartridge setting part malfunctions or not.
☞4600
2. Perform recovery procedure 1 from the replenishment error.
☞4610
Check that the replenisher cartridge setting part operates normally.
☞35320
Failed part Manual No.
Replenisher Cartridge Position Sensor (Upper)
☞63280
Replenisher Cartridge Position Sensor (Lower)
Replenisher Cartridge Open Motor
Interlock Switch (Replenisher Section Door)
F replenishment I/O PCB
☞66800
Processor control PCB ☞66200
Suffix number Condition
Distributed by: minilablaser.com
To Next Page
Loading...