Fujitsu 1FINITY L100 - Page 135

Warning: The aachment screws menoned in this step must be lined up straight in the holes and should
easily turn, right up to the point of being ght. If any resistance occurs in the rst turn, stop immediately, or
risk damage to the blade (broken screws and screw holes on the blade).
Figure 66
Aachment Screws
Step 6
Replace the protecon cover on the power terminal adapter.
Figure 67
Aaching Protecon Cover
✓ This task is complete.
Addional Instrucons:
Perform the same procedure for each blade being installed.
Equipment Installation
Install Power Terminal Adapter
135
Release 19.1.1 · Issue 1.1, May 2021
Fujitsu and Fujitsu Customer Use Only