Fujitsu 1FINITY L100 - Page 379

Figure 126
Seang Adapter
Step 24
Review the posion of the power terminal adapter on the blade, verifying that no gap exists between the power
terminal adapter and the blade and that the power terminal adapter is slightly below the top of the blade.
Figure 127
Correcng Power Terminal Adapter Placement
Step 25
On a at ESD-safe surface, alternately ghten the aachment screws to secure the power terminal adapter onto
the blade, careful not to overghten them or ghten one screw completely before the other screw.
System Maintenance
Equipment Replacement
379
Release 19.1.1 · Issue 1.1, May 2021
Fujitsu and Fujitsu Customer Use Only