Danger: Verify power to the blade has been turned OFF and follow all local electrical safety procedures
when working with electrical circuits to prevent possible serious injury or death.
Step 2
Remove the power cables from the power terminal adapter by performing the following substeps:
Note: The SYS LED indicator on the front of the blade and PWR LED on the rear of the blade are both turned
OFF when power to the blade is shut o.
-48V
FC9549SD11 Iss.01
MAIN AMAIN B
FGGAGBG
s8102cq_1
Figure 173
Removing Power Cables
a) Detach the power feed B cable (red/white) from the terminal marked MAIN B on the power terminal adapter.
b) Detach the ground cable (black/white) for the B power feed from the terminal marked GB on the power
terminal adapter.
c) Detach the power feed A cable (red) from the terminal marked MAIN A on the power terminal adapter.
Equipment Removal
Remove Power Cables
434
Release 19.1.1 · Issue 1.1, May 2021
Fujitsu and Fujitsu Customer Use Only
To Next Page
Loading...
