Fujitsu 1FINITY L100 - Page 5

5.7 Log On NE Through LMP p. 183
5.8 Provision Main Blade Ports and Fan Units p. 185
5.9 Enable Auto Shelf ID Assignment for Tributary Blade Feature p. 188
5.10 Set Up Tributary Blade with Auto Shelf ID Assignment Enabled p. 189
5.11 Set Up Tributary Blade without Auto Shelf ID Assignment Enabled p. 191
5.12 Provision L100 Tributary Blade and Ports p. 192
5.13 Provision L110 Tributary Shelf, Ports, and Slots p. 195
5.14 Provision L160 Tributary Blade p. 197
5.15 Verify Blade Setup p. 199
5.16 Set ROADM Constraints p. 200
6 System Administraon p. 201
6.1 Default Sengs and IP Port Informaon p. 202
6.2 About CLI p. 204
6.2.1 CLI Operaonal Mode p. 204
6.2.2 CLI Conguraon Mode p. 205
6.2.3 CLI Command Prompts p. 207
6.2.4 User Guide CLI Command Prompt Convenon p. 207
6.2.5 CLI User Permissions p. 208
6.2.6 CLI Command Compleon p. 208
6.2.7 CLI Command Comments p. 209
6.2.8 CLI Messages p. 209
6.3 System Name p. 211
6.4 System Time and Date p. 212
6.4.1 Show System Time and Date p. 212
6.4.2 Set System Time and Date Manually p. 212
6.4.3 Congure NTP p. 212
6.4.4 Congure System Time Zone p. 213
6.5 ILF Administraon p. 215
6.6 System Feature Administraon p. 216
6.6.1 AutoP p. 216
6.6.2 RASIS p. 216
6.6.3 neMgmtMode p. 217
6.6.4 Telemetry, Streaming p. 218
6.6.5 ZTP p. 218
6.6.6 ZTP-Boot p. 219
6.6.7 Zeroize System p. 219
6.6.8 Congure AINS p. 221
6.7 User Administraon p. 223
6.7.1 Password Rules p. 223
6.7.2 Username Rules p. 225
6.7.3 User Group Permissions p. 225
6.7.4 Create/Edit/Delete User p. 226
6.7.5 Show Users p. 227
5
Release 19.1.1 · Issue 1.1, May 2021
Fujitsu and Fujitsu Customer Use Only